Jabra 6317-208-102 Manuel d'utilisateur télécharger pdf (Page 17)

4c For use with desk phone with GN 1000 (remote handset lifter)

The GN 1000 lifts or lowers your handset automatically, allowing you to answer and end

calls when you’re away from your desk.

Jabra Bluetooth Hub setup

Connecting your Jabra Bluetooth Hub with desk phone and power supply

•

Disconnect the handset from your desk phone (by unplugging the handset from the

socket on the desk phone).

•

Connect the handset to your Bluetooth Hub’s handset socket .

•

Connect the desk phone handset socket to the Bluetooth Hub desk phone socket 

using the supplied connection cord (desk phone-to-Bluetooth Hub

•

Connect the GN 1000 to the AUX socket  on the Bluetooth Hub (see GN 1000 User

Manual

•

Connect the power supply to your Bluetooth Hub’s power supply socket .

•

Connect the power supply to the wall power socket.

•

You can use the ‘wire guide’ at the bottom of the Bluetooth Hub to neatly guide the

cable from the desk phone to the wall phone plug.

The green LED

 indicates that the Bluetooth Hub power is on.

Please refer to the GN 1000 User Manual for directions on how to set up your GN 1000.

When the LED

 is green and the GN 1000 is installed, please move on to “Adjust setting

with a test call from your desk phone” instructions.

In the unlikely event that the Bluetooth Hub is not OK, its LED

 will flash red.

•

First, try disconnecting and reconnecting the Bluetooth Hub from the power source.

•

If the LED is still flashing red, you must reset your Bluetooth Hub.

o Press and hold the Bluetooth Hub reset button

.

o The reset light will turn solid red for 3 seconds, and then turn green.

•

If the LED is still flashing red, after disconnect and reset, please contact your dealer.

IMPORTANT: Following reset, you must pair your Bluetooth Hub and headset.

English

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Pas de commentaire

Jabra 6317-208-102 Manuel d'utilisateur Page 17